Special Solenoid Input tester

Reference: DB-09-010

Condition: New product

Special solenoid circuit tester board for Williams System 3 through early System 11, and early Data East. Allows for easy bench testing, eliminates need for cumbersome test leads. Comes pre-assembled, ready to use upon arrival.

New 2017 version, with just the right number of buttons. Much easier to use.

More details

59 Item Items

In Stock

Send to a friend

Send to a friend

Special Solenoid Input tester

Special solenoid circuit tester board for Williams System 3 through early System 11, and early Data East. Allows for easy bench testing, eliminates need for cumbersome test leads. Comes pre-assembled, ready to use upon arrival.

New 2017 version, with just the right number of buttons. Much easier to use.

Recipient :

Name of your friend ^* :

E-mail address of your friend ^* :

^* Required fields

or Cancel
Print

More info

Simply plug the tester board connector into the special solenoid switch input connector on your driver board, then run the attached alligator clip lead to any available ground connection. Once connected, the 6 push buttons on the diagnostic board will act as playfield switches would for your special solenoids. System 3-7 connections for this board are shown in the photo below.

This is intended to be used in conjunction with one of my LED solenoid testers connected at 2J12. Pushing the individual buttons on this tester should cause the matching LED for that circuit to light. If it does not light up, that indicates a problem on your driver board.

On the special solenoid testers there is also a black test loop present. This is an extension of the ground that you connected the alligator clip to.