Solenoid Output Tester

Reference: DB-08-010

Condition: New product

Solenoid output test board for Williams System 3 through WPC-95, plus Data East, Sega/Stern Whitestar.

Checks the status of your solenoid outputs, but also many other logic outputs such as displays and sound headers.

New version with much cleaner, easier to read, and easier to access layout.

More details

119 Item Items

In Stock

Send to a friend

Send to a friend

Solenoid Output Tester

Solenoid output test board for Williams System 3 through WPC-95, plus Data East, Sega/Stern Whitestar.

Checks the status of your solenoid outputs, but also many other logic outputs such as displays and sound headers.

New version with much cleaner, easier to read, and easier to access layout.

Recipient :

Name of your friend ^* :

E-mail address of your friend ^* :

^* Required fields

or Cancel
Print

More info

Visual indicator of solenoid circuit status, along with many other circuits. Compatible with all Williams machines from System 3 through WPC-95. Also works with Data East, and Sega/Stern Whitestar generation boards.

This tester has a 9-pin molex connecter attached to the underside, which press-fits onto any of your 9 pin molex driver board connectors. Run the red alligator clip to any convenient +5vdc power source, and installation is complete. If you're running muliple testers, as shown below, a pass-thru is provided on a red test loop connector. Once connected, simply activate a solenoid circuit via any available means, and it will lite up the associated green LED on the bar graph.

The photo below shows a System 7 driver board set up for a full solenoid test. Running it through the factory test sequence on the CPU board will light each solenoid in sequence. In conjunction with one of the "special" solenoid input boards, this will also test both the CPU fired, and special circuit fired paths for your special solenoids.

Can also be used on your display headers, and sound output headers too.