Special Solenoid Input tester View larger

Online only

Special Solenoid Input tester

DB-04-011-Special

New product

Special solenoid circuit tester board for Williams System 3 through early System 11, and early Data East. Allows for easy bench testing, and eliminates the need for piles of bulky and cumbersome test leads. Comes pre-assembled,  ready to use upon arrival.

New 2014 version now shipping, photo still shows earlier version temporarily.

More details

1 Item

In Stock

Warning: Last items in stock!

$9.00

More info

Simply plug the tester board connector into the special solenoid switch input connector on your driver board,  then run the attached alligator clip lead to any available ground connection. Once connected, the dip switches on the diagnostic board will act as playfield switches would for your special solenoids.  System 3-7 connections for this board are shown in the photo below.

This is intended to be used in conjunction with one of my LED solenoid testers connected at 2J12,  and closing dip switches on this tester should cause the matching LED for that circuit to light.  If it does not light up, that indicates a problem on your driver board.

On the special solenoid testers there is also a black test loop present.  This is an extension of the ground that you connected the alligator clip to.

Reviews

No customer reviews for the moment.

Write a review

Special Solenoid Input tester

Special Solenoid Input tester

Special solenoid circuit tester board for Williams System 3 through early System 11, and early Data East. Allows for easy bench testing, and eliminates the need for piles of bulky and cumbersome test leads. Comes pre-assembled,  ready to use upon arrival.

New 2014 version now shipping, photo still shows earlier version temporarily.

Customers who bought this product also bought:

8 other products in the same category: