Diagnostic tools for pinball machines.
VERY handy tester piece, designed for a quick and definitive test of Bally / Williams flipper opto boards used in WPC Fliptronics machines. Works with factory Type 1, Type 2, and aftermarket opto boards. Tester board is shipped fully assembled, just needs you to assemble the small wiring harness.
Budget switch matrix tester, giving an input for 8x8 switch matricies. Compatible with any pinball machine using an 8x8 or smaller switch matrix layout. Includes dedicated jumper for Williams WPC machines. Pre-assembled wiring harness Included! Just choose from System 3-7, System 9-11, or WPC.
Lamp matrix simulator board. These simulate the playfield lamp matrix using a toolbox friendly 8x8 LED matrix, allowing you to quickly isolate a controlled lamp problem Compatible with Williams System 3 through to WPC-95, Data East. Limited compatibility with Sega/Stern 'Whitestar' and SAM systems. Pre-assembled wiring harness Included!
Allows you to view the display outputs for 6 digit or 7 digit display outputsbench testing. No more having to install the boards into machine just to read the audits, or having to hook into a massive factory test rig from the late 70's. Includes assembled wiring harness, you just need to supply a 5v power source via the included power cord
Only a couple left, new version incoming for late May, 2016. Quick plug-in board that gives you push buttons and switches to operate your diagnostic inputs. Works with System 3 through System 11, to act as substitutes for your coin door diagnostic switches. Very handy little board, particularly for bench testing.
Special solenoid circuit tester board for Williams System 3 through early System 11, and early Data East. Allows for easy bench testing, and eliminates the need for piles of bulky and cumbersome test leads. Comes pre-assembled, ready to use upon arrival. New 2014 version now shipping, photo still shows earlier version temporarily.