Restock coming very soon, available for back-order. Adapters to LED's in your classic Bally / Stern's machines. No soldering, no crimping, no tools required. Converts your existing main lamp driver board to be LED compatible so you can use any pinball LED's on the market. Converts only the main lamp driver board, but not an AUX lamp board if present.
Latest version of the always popular replacement boards for drop target sliders. Now sized to fit better, and with cleaner surface mount parts that are pre-soldered for the game you need! Simply order the number you need, and in the comments tell me which game its for. Priced PER TARGET. Only a few left in this run but more on the way soon.
Available again September 1st or so, waiting on more LED blocks. Lamp matrix simulator board. These simulate the playfield lamp matrix using a toolbox friendly 8x8 LED matrix, allowing you to quickly isolate a controlled lamp problem. Compatible with Williams System 3 through to WPC-95, Data East. Limited compatibility with Sega/Stern 'Whitestar' and SAM...
Quick plug-in board that gives you push buttons and switches to operate your diagnostic inputs. Works with System 3 through System 11, to act as substitutes for your coin door diagnostic switches. Very handy little board, particularly for bench testing.
Budget switch matrix tester, giving an input for 8x8 switch matricies. Compatible with any pinball machine using an 8x8 or smaller switch matrix layout. Includes dedicated jumper for Williams WPC machines. Pre-assembled wiring harness Included! Just choose from System 3-7, System 9-11, or WPC. Whoops, ran out, more are on order. Should be here...
Wire! 22 gauge stranded, two conductor wiring, individually insulated conductors with red and black coloring. Plus an external shielding wrap.
Solenoid output test board for Williams System 3 through WPC-95, plus Data East, Sega/Stern Whitestar. Checks the status of your solenoid outputs, but also many other logic outputs such as displays and sound headers. New version with much cleaner, easier to read, and easier to access layout.
Extra pre-assembled wiring harnesses for your lamp matrix testers. Pre-assembled and ready to go.
4 conductor 22 gauge stranded wire. Individually insulated in red, black, yellow and green. No shielding. Priced per foot.
VERY handy tester piece, designed for a quick and definitive test of Bally / Williams flipper opto boards used in WPC Fliptronics machines. Works with factory Type 1, Type 2, and aftermarket opto boards. Tester board is shipped fully assembled, just needs you to assemble the small wiring harness.
Extra wire harness for your switch matrix test board. Pre-assembled and ready to use.
Special solenoid circuit tester board for Williams System 3 through early System 11, and early Data East. Allows for easy bench testing, eliminates need for cumbersome test leads. Comes pre-assembled, ready to use upon arrival. New 2017 version, with just the right number of buttons. Much easier to use.